2009 Chrysler Aspen Owner Manual - Page 210
2009 Chrysler Aspen Manual
Page 210 highlights
208 UNDERSTANDING YOUR INSTRUMENT PANEL Vehicle Warning Messages For non-Electronic Vehicle Information Center (EVIC) equipped vehicles, when the appropriate conditions exist, messages such as "door ajar" (indicates that a door(s) may be ajar), "gASCAP" (which indicates that your gas cap is possibly loose or damaged), ЉCHANgE OIL" (indicates that the engine oil should be changed), "LoWASH" (low washer fluid), and "noFUSE" (indicates that the IOD fuse is removed from the Integrated Power Module), will display in the odometer. NOTE: If the vehicle is equipped with an EVIC, most warnings will display in the EVIC. For additional information, refer to "Electronic Vehicle Information Center (EVIC) - If Equipped" in Section 3. The outside temperature will display in the odometer for non-EVIC equipped vehicles. Pressing the trip odometer RESET button toggles the feature back to the odometer. Change Oil Message Your vehicle is equipped with an engine oil change indicator system. The "Change Oil" message will flash in the instrument cluster odometer for approximately 12 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the Trip Odometer button on the instrument cluster. To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure. 1. Turn the ignition switch to the ON position (Do not start the engine).