2015 Chrysler Town & Country User Guide - Page 16

G E T T I N G S TA R T E D • After pushing the Keyless Enter-N-Go™ LOCK button, you must wait two seconds before you can lock or unlock the vehicle using the door handle. This is done to allow you to check if the vehicle is locked by pulling the door handle, without the vehicle reacting and unlocking. • If a Keyless Enter-N-Go™ door handle has not been used for 72 hours, the Keyless Enter-NGo™ feature for that handle may time out. Pulling the deactivated front door handle will reactivate the door handle's Keyless Enter-N-Go™ feature. Lock Or Unlock The Liftgate: • With a valid Passive Entry RKE transmitter within 5 ft (1.5 m) of the liftgate, cycle the handle to open the liftgate and pull the liftgate open with one fluid motion. NOTE: • All doors will remain locked when the liftgate release handle is pushed regardless of the driver's door unlock preference setting ("Unlock Driver Door 1st Press" or "Unlock All Doors 1st Press"). • Refer to your Owner's Manual on the DVD for further information. Installing And Removing The ENGINE START/STOP Button Installing The Button • Remove the Key Fob from the ignition switch. • Insert the ENGINE START/STOP button into the ignition switch with the lettering facing up and readable. • Push firmly on the center of the button to secure it into position. Removing The Button • The ENGINE START/STOP button can be removed from the ignition switch for Key Fob use. • Insert the metal part of the emergency key under the chrome bezel at the 6 o'clock position and gently pry the button loose. NOTE: The ENGINE START/STOP button should only be removed or inserted with the ignition in the LOCK position (OFF position for Keyless Enter-N-Go™). Removing START/STOP Button Engine Starting/Stopping Starting Perform the following starting procedure with a Remote Keyless Entry (RKE) transmitter inside the vehicle: 1. Place the shift lever in PARK or NEUTRAL. 14