2015 Chrysler Town & Country User Guide - Page 53

O P E R AT I N G YO U R V E H I C L E PARKSENSE® REAR PARK ASSIST If an object is detected behind the rear bumper while the vehicle is in REVERSE, a warning will display in the instrument cluster and a tone will sound, (closer the object the faster the tone) that changes speed depending on the distance of the object from the bumper, will sound. When the Instrument Cluster reads either "Clean Sensor" or "Blinded", clean off the bumper sensors to see if the condition is corrected. PARKVIEW® REAR BACK-UP CAMERA You can see an on-screen image of the rear of your vehicle whenever the shift lever is put into REVERSE. The ParkView® Rear Back-Up Camera image will be displayed on the radio display screen, located on the center stack of the instrument panel. If the radio display screen appears foggy, clean the camera lens located on the liftgate. Refer to your Owner's Manual on the DVD for further details. WARNING! Drivers must be careful when backing up; even when using the ParkView® Rear Back-Up Camera. Always check carefully behind your vehicle, and be sure to check for pedestrians, animals, other vehicles, obstructions, or blind spots before backing up. You must continue to pay attention while backing up. Failure to do so can result in serious injury or death. BLIND SPOT MONITORING WITH REAR CROSS PATH The Blind Spot Monitoring (BSM) system uses two radar-based sensors, located inside the rear bumper fascia, to detect Highway licensable vehicles (automobiles, trucks, motorcycles etc.) that enter the blind spot zones from the rear/front/side of the vehicle. The Blind Spot Monitoring (BSM) system warning light, located in the outside mirrors, will illuminate if a vehicle moves into a blind spot zone. The BSM system can also be configured to sound an audible (chime) alert and mute the radio to notify you of objects that have entered the detection zones. Refer to your Owner's Manual on the DVD for further details. 51