2015 Chrysler Town & Country User Guide - Page 90
2015 Chrysler Town & Country Manual
Page 90 highlights
ELECTRONICS PROGRAMMABLE FEATURES Electronic Vehicle Information Center (EVIC) - If Equipped Personal Settings allows you to set and recall features when the transmission is in PARK. If the transmission is out of PARK or the vehicle begins moving, a warning message SYSTEM SETUP NOT AVAILABLE VEHICLE NOT IN PARK displays when you try to select "System Setup" from the main menu. The EVIC can be used to program the following Personal Settings. Push the RIGHT arrow button until Personal Settings displays, then push the DOWN button to scroll through the settings. Push the RIGHT arrow button to change the setting. • Select Language • Nav-Turn By Turn • Auto Lock Doors • Auto Unlock Doors • Remote Unlock Sequence • Remote Start Comfort Sys. • Horn with Remote Lock • Flash Lamps With Lock • Headlamp Off Delay • Headlamps With Wipers • Key-Off Power Delay • Illuminated Approach • Hill Start Assist • Flashers with Sliding Door • Calibrate Compass • Compass Variance • Park Assist - If Equipped • Automatic High Beams - If Equipped • Keyless Enter-N-Go - If Equipped • RKE Linked To Memory - If Equipped Key Fob Programmable Features The following features may also be programmed by using the Key Fob transmitter or the ignition switch and driver's door lock switch. NOTE: Pushing the LOCK button while you are inside the vehicle will activate the Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will cause the alarm to sound. Push the UNLOCK button to deactivate the Vehicle Security Alarm. Unlock On First Press To unlock either the driver's side, or all doors, on the first push of the UNLOCK button: • Push and hold the LOCK button for at least four seconds, but no longer than 10 seconds. Then, push and hold the UNLOCK button while still holding the LOCK button. • Release both buttons at the same time. Auto Unlock Doors On Exit To have all of the vehicle doors unlock when any door is opened: • Enter your vehicle and close all the doors, and fasten your seat belt. • Cycle the ignition switch between the LOCK and ON position four times, ending in the LOCK position (do not start the engine). 88