2013 Dodge Durango Owner's Manual - Page 206

204 UNDERSTANDING THE FEATURES OF YOUR VEHICLE To Activate 1. Enable the Automatic High Beams. Refer to "Electronic Vehicle Information Center (EVIC)/CustomerProgrammable Features" in "Understanding Your Instrument Panel" for further information. Daytime Running Lights - If Equipped The Daytime Running Lights (low intensity) come on whenever the engine is running, and the transmission is not in the PARK position. The lights will remain on until the ignition is switched to the OFF or ACC position or the 2. Turn the headlight switch to the AUTO headlight posi- parking brake is engaged. The headlight switch must be used for normal nighttime driving. tion. 3. Push the multifunction lever away from you (toward Headlight Delay front of vehicle) to engage the high beam mode. To aid in your exit, your vehicle is equipped with a NOTE: This system will not activate until the vehicle is headlight delay that will leave the headlights on for approximately 90 seconds. This delay is initiated when at or above 20 mph (32 km/h). the ignition is turned OFF while the headlight switch is To Deactivate on, and then the headlight switch is cycled off. Headlight 1. Pull the multifunction lever toward you (or rearward in delay can be cancelled by either turning the headlight car) to manually deactivate the system (normal operation switch on then off, or by turning the ignition ON. of low beams). 2. Push back on the multifunction lever once again to reactivate the system.