2013 Dodge Durango Owner's Manual - Page 449

STARTING AND OPERATING 447 NOTE: If the ignition switch is left in the ACC or RUN (engine not running) position and the transmission is in PARK, the system will automatically time out after 1. Place the shift lever in PARK, then press and release 30 minutes of inactivity and the ignition will switch to the the ENGINE START/STOP button. OFF position. 2. The ignition switch will return to the OFF position. Keyless Enter-N-Go™ Functions - With Driver's 3. If the shift lever is not in PARK, the ENGINE START/ Foot OFF The Brake Pedal/Clutch Pedal STOP button must be held for two seconds and vehicle (In PARK Or NEUTRAL Position) speed must be above 5 mph (8 km/h) before the The Keyless Enter-N-Go™ feature operates similar to an engine will shut off. The ignition switch position will ignition switch. It has four positions, OFF, ACC, RUN remain in the ACC position until the shift lever is in and START. To change the ignition switch positions PARK and the button is pressed twice to the OFF without starting the vehicle and use the accessories position. If the shift lever is not in PARK and the follow these steps. ENGINE START/STOP button is pressed once, the EVIC (if equipped) will display a "Vehicle Not In • Starting with the ignition switch in the OFF position: Park" message and the engine will remain running. • Press the ENGINE START/STOP button once to Never leave a vehicle out of the PARK position, or it change the ignition switch to the ACC position (EVIC could roll. displays "IGNITION MODE ACCESSORY"), To Turn Off The Engine Using ENGINE START/STOP Button 5