2013 Dodge Durango Owner's Manual - Page 270

268 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transTo reprogram a channel that has been previously trained, mission - which may not be long enough for HomeLink® follow these steps: to pick up the signal during programming. Similar to this 1. Cycle the ignition to the ON/RUN position. Canadian law, some U.S. gate operators are designed to time-out in the same manner. 2. Press and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. Do It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage not release the button. door or gate motor. 3. Without releasing the button proceed with "Programming A Non-Rolling Code" Step 2 and follow all 1. Cycle the ignition to the ON/RUN position. remaining steps. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) Canadian/Gate Operator Programming away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. For programming transmitters in Canada/United States Reprogramming A Single HomeLink® Button that require the transmitter signals to "time-out" after several seconds of transmission.