2015 Dodge Challenger User Guide - Page 143

ELECTRONICS 3. Simultaneously push and hold both the Homelink® button you want to program and the hand-held transmitter button. 4. Continue to hold buttons until the DID display changes from "CHANNEL # TRAINING" to "CHANNEL # TRAINED", then release both buttons. NOTE: If the DID displays "DID NOT TRAIN" repeat from Step 2. 5. At the garage door opener motor (in the garage), locate the "LEARN" or "TRAINING" button. This can usually be found where the hanging antenna wire is attached to the garage door opener motor. Firmly push and release the "LEARN" or "TRAINING" button. NOTE: You have 30 seconds in which to initiate the next step after the LEARN button has been pushed. 6. Return to the vehicle and push the programmed HomeLink® button twice (holding the button for two seconds each time). The DID will display "CHANNEL # TRANSMIT". If the garage door opener/device activates, programming is complete. NOTE: If the device does not activate, push the button a third time (for two seconds) to complete the training. 7. To program the remaining two HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels. Programming A Non-Rolling Code • For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. 3. Simultaneously push and hold both the HomeLink® button you want to program and the hand-held transmitter button. 4. Continue to hold buttons until the DID display changes from "CHANNEL # TRAINING" to "CHANNEL # TRAINED", then release both buttons. 5. Push and hold the programmed HomeLink® button and observe the indicator light. NOTE: • If the DID displays "DID NOT TRAIN" repeat from Step 2. • To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels. 141