2001 Ford Windstar Owner Guide 3rd Printing - Page 247

Maintenance and care To install the new bulb: Handle a halogen headlamp bulb carefully and keep out of children's reach. Grasp the bulb only by its plastic base and do not touch the glass. The oil from your hand could cause the bulb to break the next time the headlamps are operated. 1. With the flat side of the new bulb's plastic base facing upward, insert the glass end of the bulb into the lamp assembly. Turn the bulb left or right to align the grooves in the plastic base with the tabs in the lamp assembly. When the grooves are aligned, push the bulb into the lamp assembly until the plastic base contacts the rear of the lamp assembly. 2. Install the bulb retaining ring over the plastic base until it contacts the rear of the socket by rotating clockwise until you feel a "stop." 3. Connect the electrical connector into the rear of the plastic base until it snaps, locking it into position. 4. Install the headlamp on vehicle by aligning the lamp with the rear retainer, push rearward and secure with two retainer pins. 5. Turn the headlamps on and make sure they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again. Replacing front parking/turn signal bulbs Note size and location of retainer pins for installation. 1. At the back of the headlamp, pull two retainer pins up to release the headlamp assembly. 2. Pull headlamp assembly forward disengaging the lamp from the rear retainer to expose the back of the bulb. 247