2005 Ford F150 Owner Guide 5th Printing - Page 94
2005 Ford F150 Manual
Page 94 highlights
Locks and Security Power door unlock/lock procedure You must complete Steps 1-5 within 30 seconds, or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait a minimum of 30 seconds to begin again. 1. Turn the ignition to the 3 (ON) control three times. position, then press the 2. Turn the ignition to the 1 (OFF/LOCK) position, then press the control three times. 3. Turn the ignition to the 3 (ON) position; the horn will chirp to indicate the driver configuration mode has been activated. then the control. Note: One horn 4. Within five seconds, press chirp should be heard, indicating the system has been disabled. Conversely, a horn chirp followed by a honk will indicate the system is control then the control will turn the enabled. Pressing the feature ON if it was previously OFF, or OFF if it was previously ON. The horn will chirp once if autolock was deactivated or twice (one short chirp and one long honk) if autolock was activated. 5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming. Note: After exiting the driver configuration mode, the horn will chirp once to indicate a feature has been activated/deactivated. Keyless entry key pad procedure 1. Turn the ignition to the 1 (OFF/LOCK) position. 2. Close all the doors. 3. Enter 5-digit entry code 4. Press and hold the 7 • 8. While holding the 7 • 8 press the 3 • 4. 5. Release the 3 • 4. 6. Release the 7 • 8. The user should receive a horn chirp to indicate the system has been disabled or a chirp followed by a honk to indicate the system has been enabled. Message center procedure For information regarding the activation and deactivation of the autolocks feature using the message center, refer to Message center (if equipped) in the Driver Controls chapter. 94 2005 F-150 (f12) Owners Guide (post-2002-fmt) USA (fus)