2009 Ford E250 Cargo Owner Guide 2nd Printing - Page 109

Seating and Safety Restraints 3. At a moderate speed, buckle then unbuckle the safety belt three times, ending with the safety belt in the unbuckled state. • After Step 3 is complete, the safety belt warning light will be turned on for three seconds. • Belt-Minder௡ will automatically exit programming mode without changing its enable status if Step 4 does not occur within 10 seconds of the end of Step 3. 4. Within approximately seven seconds of the light turning off, buckle then unbuckle the safety belt. • This will disable the Belt-Minder௡ feature for that seating position if it is currently enabled. As confirmation, the safety belt warning light will flash four times per second for three seconds. • This will enable the Belt-Minder௡ feature for that seating position if it is currently disabled. As confirmation, the safety belt warning light will flash four times per second for three seconds, followed by three seconds with the light off, then followed by the safety belt warning light flashing four times per second for three seconds again. 5. After receiving confirmation, the deactivation/activation procedure is complete. Safety belt extension assembly If the safety belt is too short when fully extended, there is a 9 inch (23 cm) or 12 inch (31 cm) safety belt extension assembly that can be added (part number 611C22). This assembly can be obtained from an authorized dealer. Use only extensions manufactured by the same supplier as the safety belt. Manufacturer identification is located at the end of the webbing on the label. Also, use the safety belt extension only if the safety belt is too short for you when fully extended. Use the shortest extender assembly that will provide adequate fit. WARNING: Do not use extensions to change the fit of the shoulder belt across the torso. 109 2009 Econoline (eco) Owners Guide, 2nd Printing USA (fus)