2013 Ford E350 Super Duty Passenger Owner Manual Printing 3 - Page 88

Information Displays Compass zone adjustment 87 1. Determine which magnetic zone you are in for your geographic 15 location by referring to the zone 3 2 1 map. 4 14 2. Press and release the 13 SELECT/RESET stem to scroll 5 12 through the information displays until the message center displays HOLD RESET FOR SETUP MENU. 6 7 8 9 1011 3. Press and hold the SELECT/RESET stem to get into the setup menu. Repeatedly press it again to scroll through the setup menu until the message center displays COMPASS ZONE XX. 4. Press and hold the SELECT/RESET stem for approximately two seconds to go to the next zone, then release. 5. Press and hold to go up by one zone then release. Repeat this until you reach the desired zone. 6. Release the SELECT/RESET stem and allow the setup timer to expire to exit the procedure Compass calibration adjustment Note: For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential electrical accessories (heated rear window, heater, A/C, map lamps, wiper, etc.) and make sure all the doors are closed Note: If the SELECT/RESET stem is pressed during the calibration or three minutes has elapsed since the beginning of the calibration without driving the vehicle, the message center reverts back to normal operation and the CAL will display until a successful calibration is carried out. 1. Press and release the SELECT/RESET stem to scroll through the information displays until the message center displays HOLD RESET FOR SETUP MENU. 2. Press and hold the SELECT/RESET stem to get into the setup menu. Repeatedly press it again to scroll through the setup menu until the message center displays HOLD RESET FOR CALIBRATION. 2013 Econoline (eco) Owners Guide gf, 3rd Printing, May 2013 USA (fus)