1994 GMC Jimmy Owner's Manual - Page 287

Using Foam-Type Cleaner on Fabric 0 0 Vacuum and brush the area toremove any loose dirt. Always clean a whole trim panel or section. Mask surrounding trim along stitch or welt lines. Mix Multi-Purpose Powdered Cleaner following the directions on the container label. Use suds only and apply with a clean sponge. Don't saturate the material. 0 0 0 Don't rub it roughly. As soon as you've cleaned the section, usea sponge to remove the suds. Rinse the section with a clean, wet sponge. Wipe off what's left with a slightly damp paper towel or cloth. Then dry it immediately with a blow dryer or a heat lamp. 0 NOTICE: 1 Be careful with a hair dryer or heat lamp. could scorch the You fabric. 0 Wipe with a clean cloth. Using Solvent-Type Cleaner on Fabric First, see if you have to use solvent-type cleaner at all. Some spots and stains will clean better withjust water and mild soap. off If you need to use solvent: a 0 Gently scrape excess soilfrom the trim material witha clean, dull knife or scraper. Use very little cleaner, light pressure and clean cloths (preferably cheesecloth).Cleaning should start at the outsideof the stain, "feathering" toward the center. Keep changing to a clean section of the cloth. When you clean a stain from fabric, immediately dry the area with an air hose, hair dryer,or heat lamp to helpprevent a cleaning ring. (See - . the previous NOTICE.) , , 0 6-51