2006 Jeep Grand Cherokee Owner's Manual - Page 155
2006 Jeep Grand Cherokee Manual
Page 155 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 155 NOTE: Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the Gate Operator/Canadian Programming section. 4. The EVIC display will show "CHANNEL X TRAINING" (where X is Channel 1, 2, or 3). Release both buttons after the EVIC display shows "CHANNEL X TRAINED." NOTE: If the EVIC display shows "DID NOT TRAIN" repeat steps 2-4. 5. Press and hold the just trained HomeLink button and observe the EVIC display. If the EVIC display shows "CHANNEL X TRANSMIT" (where X is Channel 1, 2, or 3), programming is complete and your device should activate when the HomeLink button is pressed and released. 3 HomeLink Buttons 2. Position the end of your hand-held transmitter 1-3 inches (3-8 cm) away from the HomeLink buttons. 3. Simultaneously press and hold both the HomeLink button that you want to train and the hand-held transmitter buttons. Do not release the buttons until step 4 has been completed.