2006 Jeep Grand Cherokee Owner's Manual - Page 158

•

Press and hold the two outer HomeLink buttons and

release only when the EVIC display shows “CHAN-

NELS CLEARED” (after 20 seconds). Release both

buttons. Do not hold for longer that 30 seconds.

HomeLink is now in the train (or learning) mode and

can be programmed at any time beginning with

²

Pro-

gramming

²

- Step 2.

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink

button previously trained, follow these steps:

1. Press and hold the desired HomeLink button.

Do

NOT

release the button.

2. The EVIC display will show “CHANNEL X TRANS-

MIT” (where X is Channel 1, 2, or 3) for 20 seconds and

then change to “CHANNEL X TRAINING.” Without

releasing the HomeLink button, proceed with

²

Program-

ming

²

Step 2.

For

questions

or

comments,

contact

HomeLink

at:

www.homelink.com or 1-800-355-3515

.

Security

If you sell your vehicle, be sure to erase the frequencies

by following the “Erasing HomeLink Buttons” instruc-

tions in this section.

This device complies with part 15 of FCC rules and with

RSS-210 of Industry Canada. Operation is subject to the

following conditions:

•

This device may not cause harmful interference.

•

This device must accept any interference that may be

received including interference that may cause undes-

ired operation.

NOTE:

Changes or modifications not expressly ap-

proved by the party responsible for compliance could

void the user’s authority to operate the equipment.

158

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

2006 Jeep Grand Cherokee Owner's Manual - Page 158

2006 Jeep Grand Cherokee Manual

Page 158 highlights