2006 Jeep Grand Cherokee Owner's Manual - Page 262

262 STARTING AND OPERATING FOUR-WHEEL DRIVE OPERATION Quadra-Trac I Operating Instructions/Precautions - If Equipped The Quadra-Trac I is a single speed (HI range only) transfer case which provides convenient full-time 4-wheel drive. No driver interaction is required. This transfer case divides engine torque almost evenly with 48 percent of engine torque to the front axle and 52 percent of engine torque to the rear axle. The Brake Traction Control System (BTC), which combines standard ABS and Traction Control, provides resistance to any wheel that is slipping to allow additional torque transfer to wheels with traction. NOTE: The Quadra-Trac I system is not appropriate for conditions where LOW range is recommended. Refer to "Off-Road Driving Tips" in this section. Quadra-Trac II Operating Instructions/Precautions - If Equipped The Quadra-Trac II transfer case is fully automatic in the normal driving 4 HI mode. The Quadra-Trac II transfer case provides three mode positions - four wheel drive high range, neutral, and four wheel drive low range. This transfer case is fully automatic in the 4 HI mode. This transfer case divides engine torque almost evenly with 48 percent of engine torque to the front axle and 52 percent of engine torque to the rear axle. When speed differences are increased between the front and rear drive shafts, the transfer case can transmit up to 100 percent of available engine torque to the front or rear drive shafts. When additional traction is required, the 4 LOW position can be used to lock the front and rear driveshafts together and force the front and rear wheels to rotate at the same speed. The 4 LOW position is intended for loose, slippery