2002 Mazda MPV Owner's Manual - Page 177

J16L_EA.book Page 19 Friday, February 22, 2002 11:34 AM Interior Comfort Audio System • A new CD may have rough edges on its inner and outer perimeters. If a disc with rough edges is used, proper setting will not be possible and the CD player/changer will not play the CD. Remove the rough edges in advance by using a ball-point pen or pencil as shown below. To remove the rough edges, rub the side of the pen or pencil against the inner and outer perimeter of the CD. • Be sure never to touch the signal surface when handling the CDs. Pick up a CD by grasping the outer edge or the edge of the hole and the outer edge. • Do not stick paper or tape on the CD. Avoid scratching the reverse side (the side without a label). • Dust, finger smudges, and dirt can decrease the amount of light reflected from the signal surface, thus affecting sound quality. If the CD should become soiled, gently wipe it with a soft cloth from the center of the CD to the edge. • Do not use record sprays, antistatic agents, or household spray cleaners. Volatile chemicals such as benzine and thinner can also damage the surface of the CD and must not be used. Anything that can damage, warp, or fog plastic should never be used to clean CDs. • The CD player/changer has been designed to play CDs bearing the identification logo as shown. No other discs can be played. • CDs, like traditional audio records, are made of plastic. To avoid warping, keep the CDs in their cases and do not store them where they will be exposed to direct sunlight. • The CD player/changer ejects the CD if the CD is inserted upside down. Also dirty and/or defective CDs may be ejected. • 8 cm (3 in) CDs and CD accessories (e.g. 8 cm disc adapter) cannot be used in the CD player/changer. • When driving over uneven surfaces, the sound will jump. 6-19 Form No. 8Q44-EA-01K