2004 Mercury Grand Marquis Owner Guide 3rd Printing - Page 53

Driver Controls 6. DID NOT TRAIN will be displayed if the channel did not properly train. 7. Release the channel X button. Training is complete. Note: Additional training may be required for rolling code equipped devices. Refer to the Rolling code programming in this section. Rolling code programming To train a garage door opener (or other rolling code equipped devices) with the rolling code feature, follow these instructions after completing the "Train mode" in this section. (A second person may make the following training procedures quicker & easier) 1. Locate the "learn" or "smart" button on the garage door motor head unit. Exact location and color of the button may vary by product brand. If there is difficulty locating the "learn" or "smart" button refer to the device's owner manual or contact HomeLink௡ at 1-800-355-3515 or on the Internet at www.homelink.com. 2. Press and release the "learn" or "smart" button on the garage door motor head unit. Note: Following step 2, there are 30 seconds in which to initiate step 3. 3. Press and release the programmed HomeLink௡ button. Press and release the HomeLink௡ button a second time to complete the training process. (Some garage door openers may require this procedure to be done a third time to complete the training.) The rolling code equipped device should now recognize the HomeLink௡ signal and activate when the HomeLink button is pressed. The remaining two buttons may now be programmed if this has not previously been done. Refer to the "Train mode" in this section. 53 2004 Grand Marquis (grn) Owners Guide (post-2002-fmt) USA English (fus)