2002 Nissan Maxima Owner's Manual - Page 122

turned off and the last radio station played will come on. The FM stereo indicator ST will glow during FM stereo reception. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE (Tuning): button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. Station memory operations: Twelve stations can be set for the FM band (six for FM1, six for FM2) and six stations can be set for the AM band. 1. Tune to the desired station using the SEEK, SCAN or TUNE button. 2. Select the desired station and keep pushing any of the desired station memory buttons (1 to 6) until a beep sound is heard. (The radio mutes when the select button is pushed.) 3. The indicator ch2 will then come on and the sound will resume. Memorizing is now complete. 4. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse blows, the radio memory will be cancelled. In that case, reset the desired stations. (Automatic preset) button: To select the preset FM, AM or PTY station (type B only), push the AUTOP button for less than 1.5 seconds. To preset the FM, AM or PTY station, push the AUTOP button for more than 1.5 seconds. Program type - type B only: When PTY button is pressed during FM mode, the PTY name of the current tuned station is displayed. During this time if the PTY data code is zero, or the data is unreadable; the display will show NONE. 1. PTY selection mode PTY name selection can be done by the up/down TUNE button or in the PTY selection mode. It is possible to shift the PTY name by one step, with one push of the up/down tuning button or . PTY name selection can also be achieved by pressing the preset buttons. Initial PTY names are stored in the preset buttons; but these can be changed by pressing the preset buttons for more than 1.5 seconds when the desired PTY name is in the display. WARNING The radio should not be tuned while driving so full attention may be given to vehicle operation. Use these buttons for manual tuning. To move quickly through the channels, hold either of the TUNE buttons down for more than 0.5 seconds. SEEK tuning: Push the SEEK button or , to tune from high to low or low to high frequencies and stops at the next broadcasting station. SCAN tuning: Push the SCAN tuning button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the Heater, air conditioner and audio systems 4-17