2002 Nissan Maxima Owner's Manual - Page 129

display during radio operation. During cassette tape operation, TAPE illuminates in the display. TUNE (Tuning): be set for the AM band. 1. Tune to the desired station using the SCAN or TUNE buttons. 2. Select the desired station and keep pushing any of the desired station memory buttons (1 to 6) until a beep sound is heard. The radio mutes when the select button is pushed.) 3. The indicator ch2 will come on and the sound will resume. Memorizing is now complete. 4. Other station select buttons can be set in the same manner. If the battery cable is disconnected, or if the radio fuse opens, the radio memory is cancelled. In that case, reset the desired stations. Program type: When PTY button is pressed during FM mode, the PTY name of the current tuned station is displayed. During this time if the PTY data code is zero, or the data is unreadable; the display will show NONE. 1. PTY selection mode PTY name selection can be done by the up/down TUNE button or in the PTY selection mode. FM-AM radio operation FM-AM band select: Pushing the FM-AM band select button will change the band as follows: AM , AM (preset station) , FM1 , FM2 , FM (preset station) , AM When FM/AM band select button is pushed while the ignition switch is in the ACC or ON, the radio will come on at the station last played. The last station played will also come on when the power knob is turned to ON. If a compact disc or tape is playing when the FM/AM band select button is turned to ON, the compact disc or tape will automatically be turned off and the last radio station played will come on. The FM stereo indicator, ST illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. WARNING The radio should not be tuned while driving so full attention may be given to vehicle operation. Use these buttons for manual tuning. To move quickly through the channels, hold either of the TUNE buttons down for more than 0.5 seconds. SCAN tuning: Push the SCAN tuning button and SCAN will illuminate in the display window. SCAN tuning begins from high to low or low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 second period stops SCAN tuning and the radio remains tuned to that station. If any of the SEEK/SCAN tuning buttons are not pushed within 5 seconds, SCAN tuning moves to the next station. Station memory (and preset) operations: Twelve stations can be set for the FM band (six for FM1, six for FM2) and six stations can 4-24 Heater, air conditioner and audio systems