2002 Nissan Maxima Owner's Manual - Page 76

tion. Press the mode switch if you wish to return to the mode that was selected before the warning occurred. The ICY indicator will continue blinking as long as the temperature remains below 39°F (4°C). play just before the ignition switch is turned OFF may continue to be displayed. ¼ When driving uphill or rounding curves, the fuel in the tank shifts, which may momentarily change the display. Distance to empty (dte - mile or km) The distance to empty (dte) mode provides you with an estimation of the distance that can be driven before refueling. The dte is constantly being calculated, based on the amount of fuel in the fuel tank and the actual fuel consumption. The display is updated every 30 seconds. The dte mode includes a low range warning feature: when the fuel level is low, the dte mode is automatically selected and the digits blink in order to draw the driver's attention. Press the mode switch if you wish to return to the mode that was selected before the warning occurred. The dte mark (dte) will remain blinking until the vehicle is refuelled. When the fuel level drops even lower, the dte display will change to ( ). NOTE: ¼ If the amount of fuel added while the ignition switch is OFF is small, the dis- Average fuel consumption ( or ) The Average fuel consumption mode shows the average fuel consumption since the last reset. Resetting is done by pressing the mode switch for more than approximately 1 second. The display is updated every 30 seconds. At about the first 1/3 miles (500 m) after a reset, the display shows ( ). SIC1750 When the ignition switch is turned to ON, modes of the trip computer can be selected by pushing once on the trip mode switch. The following modes can be selected: Average speed ( or ) Outside air temperature (ICY - °F or °C) The outside air temperature is displayed in °F or °C. The outside air temperature mode includes a low temperature warning feature: below 37°F (3°C), the outside air temperature mode is automatically selected and ICY indicator will illuminate in order to draw the driver's atten- The average speed mode shows the average vehicle speed since last reset. Resetting is done by pressing the mode switch for more than approximately 1 minute. The display is updated every 30 seconds. The first 30 seconds after a reset, the display shows ( ). Journey time The journey time mode shows the time since the last reset. The displayed time can be reset by pressing the mode switch for more than approximately 1 second. Instruments and controls 2-31