2014 Nissan Sentra Owner's Manual - Page 267

PUSH-BUTTON IGNITION SWITCH (if so equipped) NISSAN VEHICLE IMMOBILIZER SYSTEM The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on the key ring), restart the engine using the following procedure: 1. Leave the ignition switch in the ON position for approximately 5 seconds. 2. Place the ignition switch in the OFF or LOCK position, and wait approximately 10 seconds. 3. Repeat steps 1 and 2. 4. Restart the engine while holding the device (which may have caused the interference) separate from the registered key. If the no start condition re-occurs, NISSAN recommends placing the registered key on a separate key ring to avoid interference from other devices. LSD2014 Push center ● once to change to ACC. ● two times to change to ON. ● three times to return to OFF. The ignition switch will automatically return to the LOCK position when any door is either opened or closed with the switch in the OFF position. The ignition lock is designed so that the ignition switch position cannot be switched to OFF until the shift lever is moved to the P (Park) position or N (Neutral) position (MT). WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times in quick succession or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops while the vehicle is being driven, this could lead to a crash and serious injury. When the ignition switch is pushed without depressing the brake pedal or the clutch pedal (MT), the ignition switch position will illuminate as follows: When the ignition switch cannot be pushed toward the OFF position, proceed as follows: 1. Move the shift lever into the P (Park) position or N (Neutral) position (MT). 2. Push the ignition switch. The ignition switch position will change to the ON position. 3. Push the ignition switch again to the OFF position. The shift lever can be moved from the P (Park) position if the ignition switch is in the ON position and the brake pedal is depressed. 5-10 Starting and driving