2014 Nissan Sentra Owner's Manual - Page 325

B with a wrench by 5. Remove the drain plug ᭺ turning it counterclockwise and completely drain the oil. 6. Clean and reinstall the drain plug and a new washer. Securely tighten the drain plug with a wrench. Do not use excessive force. Drain plug tightening torque: 22 - 29 ft-lb (29 - 39 N·m) 7. Refill engine with recommended oil through the oil filler opening, then install the oil filler cap securely. See "Recommended fluids/lubricants and capacities" in the "Technical and consumer information" section of this manual for drain and refill capacity. The drain and refill capacity depends on the oil temperature and drain time. Use these specifications for reference only. Always use the dipstick to determine when the proper amount of oil is in the engine. 8. Start the engine. Check for leakage around the drain plug and oil filter. Correct as required. 9. Turn the engine off and wait more than 10 minutes. Check the oil level with the dipstick. Add engine oil if necessary. If the oil filter is to be changed, remove and replace it at this time. See "Changing engine oil filter" in this section. WARNING ● Prolonged and repeated contact with used engine oil may cause skin cancer. ● Try to avoid direct skin contact with used oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible. ● Keep used engine oil out of reach of children. LDI2190 CHANGING ENGINE OIL 1. Park the vehicle on a level surface and apply the parking brake. 2. Start the engine and let it idle until it reaches operating temperature, then turn it off. A by turning it 3. Remove the oil filler cap ᭺ counterclockwise. CAUTION ● Be careful not to burn yourself. The engine oil may be hot. ● Waste oil must be disposed of properly. ● Check your local regulations. 4. Place a large drain pan under the drain plug B. ᭺ 8-10 Maintenance and do-it-yourself