2014 Nissan Sentra Owner's Manual - Page 81

COMPASS DISPLAY (if so equipped) NOTE: The ECO Pedal Indicator's bar is not displayed when the cruise control is in operation. Distance to empty The distance to empty (dte) mode provides you with an estimation of the distance that can be driven before refueling. The dte is constantly being calculated, based on the amount of fuel in the fuel tank and the actual fuel economy. The display is updated every 30 seconds. NOTE: When driving uphill or rounding curves, the fuel in the tank shifts, which may momentarily change the display. This unit measures terrestrial magnetism and indicates heading direction of vehicle. With the ignition switch in the ON position, press button as described in the chart below the to activate various features of the automatic antiglare rearview mirror. Press and hold the button for about: 0 - 3 seconds 3 - 6 seconds 6 - 9 seconds 9 - 12 seconds Feature: (Press button again for about 1 second to change settings) Compass display toggles on/off Automatic anti-glare/indicator light toggles on/off Compass zone can be changed to correct false compass readings Compass enters calibration mode Instant fuel economy The instant fuel economy mode shows the instant fuel economy. The display updates instantly when driving. Average fuel economy The average fuel economy mode shows the average fuel economy since the last reset. Resetbutton on the ting is done by pressing the steering wheel for more than approximately 1 second. The display is updated every 30 seconds. At about the first 1/3 mile (500 m) after a reset, the display shows (----). Trip computer reset To reset Trip A, Trip B, AVG/mpg, or AVG/mph, go to the desired mode on the trip computer and button on the steering wheel for hold the more than 3 seconds. Average speed The average speed mode shows the average vehicle speed since last reset. Resetting is done button on the steering by pressing the wheel for more than approximately 1 second. The display is updated every 30 seconds. The first 30 seconds after a reset, the display shows (----). OUTSIDE TEMPERATURE DISPLAY The outside temperature function provides a display of the outside temperature when the ignition switch is placed in the ON position. The display of positive temperatures is unsigned (blank), negative temperatures are prefixed with a minus sign. For more information about the automatic antiglare feature, refer to "Automatic anti-glare rearview mirror" in the "Pre-driving checks and adjustments" section. 2-8 Instruments and controls