2014 Nissan Sentra Owner's Manual - Page 91

Cruise main switch indicator light (if so equipped) The light comes on when the cruise control main switch is pushed. The light goes out when the main switch is pushed again. When the cruise main switch indicator light comes on, the cruise control system is operational. Front fog light indicator light (if so equipped) The front fog light indicator light illuminates when the front fog lights are ON. See "Fog light switch" in this section. Malfunction Indicator Light (MIL) If this indicator light comes on steady or blinks while the engine is running, it may indicate a potential emission control malfunction. The Malfunction Indicator Light may also come on steady if the fuel-filler cap is loose or missing, or if the vehicle runs out of fuel. Check to make sure the fuel-filler cap is installed and closed tightly, and that the vehicle has at least 3 gallons (11.4 liters) of fuel in the fuel tank. light should After a few driving trips, the turn off if no other potential emission control system malfunction exists. If this indicator light comes on steady for 20 seconds and then blinks for 10 seconds when the engine is not running, it indicates that the vehicle is not ready for an emission control system inspection/maintenance test. See "Readiness for inspection/maintenance (I/M) test" in the "Technical and consumer information" section of this manual. ECO mode indicator light This light comes on when the ECO mode has been selected. See "ECO mode" in the "Starting and driving" section for the use of the ECO mode switch. Front passenger air bag status light The front passenger air bag status light will be lit and the passenger front air bag will be OFF depending on how the front passenger seat is being used. For front passenger air bag status light operation, see "Front passenger air bag and status light" in the "Safety - Seats, seat belts and supplemental restraint system" section of this manual. Engine start operation indicator (if so equipped) For vehicles equipped with push button ignition this indicator illuminates when the ignition switch is in the LOCK, OFF, ACC or ON position. This indicator means that the engine will start by pushing the push-button ignition switch with the brake pedal and clutch pedal (if so equipped) depressed. High beam indicator light (blue) This blue light comes on when the headlight high beams are on and goes out when the low beams are selected. The high beam indicator light also comes on when the passing signal is activated. 2-18 Instruments and controls