2005 Subaru Baja Owner's Manual - Page 106

Keys and doors To arm the system using power door locking switches 1. Close all windows and moonroof. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood and switchback door are locked. 5. Close the doors but leave only the driver's door or the front passenger's door open. 6 ery two seconds) to inform you that the system has armed. NOTE The system can be armed even if the engine hood, the windows, the switchback door and/or moonroof are open. Always make sure that they are fully closed before arming the system. Disarming the system Briefly press the "UNLOCK/DISARM" button (for less than two seconds) on the remote transmitter. The driver's door will unlock, an electronic chirp will sound twice, the turn signal lights will flash twice and the indicator light will go off. To unlock all other doors, briefly press the "UNLOCK/ DISARM" button a second time. 7 UB2024CC 6. Push the power door locking switch forward ("LOCK" side) to set the door locks. 7. Close the door. An electronic chirp will sound once, the turn signal lights will flash once and the indicator light will start flashing slowly (approximately once ev- Emergency disarming If you cannot disarm the system using the transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the transmitter. To disarm the system: 1. Unlock the door with the key and then open the door. - CONTINUED - 2-17