2005 Subaru Baja Owner's Manual - Page 180
2005 Subaru Baja Manual
Page 180 highlights
Audio Waveband selection FM/AM selection Push the "BAND" button (2) to select FM1, FM2 or AM reception. The display indicates which one is currently selected. Stereo indicator The stereo indicator "ST" will come on when an FM stereo broadcast is received. Tuning (TUNE) Manual tuning (TUNE) Press the " " side of the tuning button (3) to increase the tuning frequency and press the " " side of the button to decrease it. Each time the button is pressed, the frequency interval can be changed between 10 kHz in the AM mode and 0.2 MHz in the FM mode. Seek tuning (SEEK) If the tuning button (3) is pressed for longer than half of a second, the radio will begin to automatically search for receivable frequencies and will stop at the first one found. This function may not be available, however, when radio signals are weak. In such a situation, perform manual tuning to select the desired station. Automatic tuning (SCAN) Press the "SCAN" button (6) to change the radio to the SCAN mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned from the low end to the high end. Press the "SCAN" button again to cancel the SCAN mode and to stop on any displayed frequency. When the "SCAN" button is pressed for automatic tuning, stations are scanned in the direction of low frequencies to high frequencies only. Automatic tuning may not function properly if the station reception is weakened by distance from the station or proximity to tall buildings and hills. Selecting preset stations Presetting a station with a "Preset" button (4) allows you to select that station in a single operation. Up to six AM, FM1 and FM2 stations each may be preset. How to preset stations 1. Press the "BAND" button (2) to select FM1, FM2 or AM reception. 2. Press the "SCAN" button or tune the radio manually until the desired station frequency is displayed. 3. Press one of the "Preset" buttons for more than 2 - CONTINUED - 5-9