2005 Subaru Baja Owner's Manual - Page 366

Maintenance and service AMERI CA The oil quantity indicated above is only a guideline. The necessary quantity of oil depends on the quantity of oil that has been drained. The quantity of drained oil differs slightly depending on the temperature of the oil and the time the oil is left flowing out. After refilling the engine with oil, therefore, you must use the dipstick to confirm that the level is correct. 14.Start the engine and make sure that no oil leaks appear around the filter's rubber seal and drain plug. 15.Run the engine until it reaches the normal operating temperature. Then stop the engine and wait a few minutes to allow the oil drain back. Check the oil level again and if necessary, add more engine oil. SL grade, you may use SJ grade "ENERGY CONSERVING" oil). These recommended oil grades can be identified by looking for either or both of the following marks displayed on the oil container. N ROLEUM PET IN ITUTE ST Recommended grade and viscosity CE Use only engine oil with the recommended grade and viscosity. R T I FI E D HSB023AA New API Certification Mark (Starburst Mark) Oil grade: ILSAC GF-3, which can be identified with the new API certification mark (Starburst mark) or API classification SL with the words "ENERGY CONSERVING" (if you cannot obtain the oil with - CONTINUED - 11-15