2010 Subaru Forester Owner's Manual - Page 190

5-26 Audio 2. Press the AUX input selection button "CD/AUX" on the audio control panel to turn on the auxiliary audio input. 3. Play back the portable audio player. Refer to the Owner's Manual of the portable audio player. volume of the audio set, the volume becomes louder. However, when you change from one portable audio player to another one, the volume levels via the vehicle's speakers may be significantly loud compared to the prior device. To avoid a large volume difference, turn down the volume when you change between portable audio players. . In some cases, when the sound volume of the portable audio player is low, the sound becomes bad when you turn up the volume of the vehicle audio system. In this case, adjust the sound volume of the portable audio player. . In some cases, noise occurs because of a bad connection between the portable player of the vehicle audio system or for the player. Audio control buttons (if equipped) These buttons are located on the steering wheel. They allow the driver to control audio functions without taking his/her hands off the steering wheel. & MODE button NOTE . The AUX jacks of the models with the genuine SUBARU navigation system are the RCA type. For detailed information, refer to the Owner's Manual supplement for the navigation system. . The output sound of the portable audio player is not loud, and the sound via the vehicle's speakers that are connected to the vehicle audio set may be very low. If you turn up the This button is used to select the desired audio mode. Each time it is pressed, the mode changes to the next one in the following sequence: *1: The frequency last received in the selected