3Com 3CRWDR101A-75-US User Guide - Page 89
RIP, Operation Mode
UPC - 662705500058
View all 3Com 3CRWDR101A-75-US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Advanced 87 RIP RIP (Routing Information Protocol) - RIP allows the network administrator to set up routing information on one RIP-enabled device and send that information to all RIP-enabled devices on the network. Figure 73 RIP Parameter Screen You can set up RIP independently on both LAN and WAN interfaces. 1 Check the Enable RIP checkbox. 2 Check the Enable Auto summary checkbox. Auto summarization sends simplified routing data to other RIP-enabled devices rather than full routing data. 3 Select the Operation Mode: ■ Disabled - RIP is not enabled for the WAN or LAN interface. ■ Enabled - RIP is enabled for the WAN or LAN interface. The router will transmit RIP update information to other RIP-enabled devices. ■ Silent - RIP is enabled, however the Router only receives RIP update messages, it will not transmit any messages itself. 4 In the Version field, select 1 or 2. 3Com recommends that you only use RIPv1 if there is an existing RIP-enabled device on your network that does not support RIPv2. In all other cases, you should use RIPv2.