AIWA NSX-MTD9 Operating Instructions - Page 44

Use the remote control. 1 Press DOLBY PRO LOGIC to select NORMAL. "NORMAL" is displayed. If "PHANTOM" or "3 STEREO" is displayed, press DOLBY PRO LOGIC repeatedly until "NORMAL" is selected. 2 Press MANUAL SELECT and hold it down for about four seconds until "L" flashes. A noise signal is sent to each channel in turn in the following sequence. 3 Adjust the sound level of the center and the surround speakers. When "CEN" or "S-R" or "S-L" is displayed, press or surround speaker to match the level of the front speakers. to adjust the volume of the center or each To adjust the balance between the left and right front speakers, see page 8. At this time, the DOLBY PRO LOGIC mode should be canceled by pressing DOLBY PRO LOGIC until "PRO-OFF" is displayed. 4 Press MANUAL SELECT again to stop the noise signal. NOTE • If the surround speakers or the center speaker level of the DOLBY PRO LOGIC is changed, that of the SURROUND system (page 12) and the DOLBY DIGITAL SURROUND (page 30) are also changed. • While "S-L" or "S-R" is displayed, both surround speakers output the signal noise together. However, only the sound level of one surround speaker is displayed as "S-L" or "S-R" can be adjusted. • When the sequencer outputs a noise signal, a clicking might be heard from the speakers due to the characteristics of the circuit. This is not malfunction. To change the delay time The surround speakers reproduce sounds a split second after the front speakers. The delay is initially set to 20 ms (milliseconds). To change the standard delay time, press MANUAL SELECT on the remote control repeatedly until "TIME" is displayed. Then, press or on the remote control. Each time one of the buttons is pressed, the delay time changes as shown below.