AIWA NSX-MTD9 Operating Instructions - Page 45
DOLBY PRO LOGIC cont., pg. 24
![]() |
View all AIWA NSX-MTD9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
DOLBY PRO LOGIC (cont.) pg. 24 PLAY WITH DOLBY PRO LOGIC 1 Press VIDEO/AUX and start playback of the video source. "VIDEO" is displayed. If "5.1 ch IN" is displayed, press VIDEO/AUX again. 2 Press DOLBY PRO LOGIC. "NORMAL" is selected, and the playback sound has the DOLBY PRO LOGIC effect. To cancel Dolby Pro Logic mode Press DOLBY PRO LOGIC repeatedly until "PRO-OFF" is displayed. To change the sound levels during playback After adjusting the balance with the noise sequencer, the sound levels of the center or each surround speaker can be adjusted during playback of laser discs or video software. 1 Press MANUAL SELECT on the remote control repeatedly to select "CEN" (center) or "S-R" (right surround speaker) or "S-L" (left surround speaker). 2 While the "CEN" or "S-R" or "S-L" is displayed, press or volume. on the remote control to adjust the ADDITIONAL DOLBY PRO LOGIC MODES In addition to the NORMAL mode, this unit is also equipped with the PHANTOM and the 3 STEREO modes. PHANTOM mode: Use this mode when no center speaker is connected. The center channel signals are output through the left and right speakers. 3 STEREO mode: Use this mode when no surround speakers are connected. This mode reproduces rear sounds
![](/manual_guide/products/aiwa-nsxmtd9-operating-instructions-5dcc3bd/45.png)