Acer AR380 F1 User Manual - Page 77
Installing an expansion card
View all Acer AR380 F1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
59 Installing an expansion card Your server has a preinstalled riser card designed specifically for use in the 2U rackmount chassis. Depending on the type of riser card installed, you can install the following expansion cards: • Left riser card (pre-installed) • One Acer Flex I/O (PCI-E 2.0 x8) slot • Two full height PCI-E 2.0 x8 slots (with x4 link) • One full height PCI-E 2.0 x16 slot (with x8 link) • Right riser card (optional) • Three low profile PCI-E 2.0 x8 slots (with x4 link) Installing a SAS card 1 Observe the pre-installation instructions on page 26. 2 Unclip the restraining latch and open in the direction shown below (1). 3 Remove the slot shield (2).
59
Installing an expansion card
Your server has a preinstalled riser card designed specifically for use in
the 2U rackmount chassis. Depending on the type of riser card
installed, you can install the following expansion cards:
•
Left riser card (pre-installed)
•
One Acer Flex I/O (PCI-E 2.0 x8) slot
•
Two full height PCI-E 2.0 x8 slots (with x4 link)
•
One full height PCI-E 2.0 x16 slot (with x8 link)
•
Right riser card (optional)
•
Three low profile PCI-E 2.0 x8 slots (with x4 link)
Installing a SAS card
1
Observe the pre-installation instructions on page 26.
2
Unclip the restraining latch and open in the direction shown
below
(1)
.
3
Remove the slot shield
(2)
.