Airlink APO1000 User Manual - Page 122

Chapter 6. Client Bridge + Universal Repeater Configuration When Client Bridge + Universal Repeater mode is activated, the system can be configured as an Access Point and Client Station simultaneously. This section provides information in configuring the Client Bridge + Universal Repeater mode with graphical illustrations. APO1000/APO1010 provides functions as stated below where they can be configured via a userfriendly web based interface. Option System Wireless Utilities Status Operating Mode General Setup Profiles Settings System Overview LAN Advanced Setup Firmware Upgrade Clients Functions Management Time Server AP Setup MAC FIlter Network Utility Reboot DHCP Clients Extra Info SNMP Site Survey UPNP Table 6-1: Client Bridge + Universal Repeater Mode Functions Event Log 6.1 External Network Connection 6.1.1 Network Requirement It can be used as an Client Bridge or Universal Repeater to receive wireless signal over last mile applications, helping WISPs deliver wireless broadband Internet service to new residential and business customers. In this mode, APO1000/APO1010 is enabled with DHCP Server functions. The wired clients of APO1000/APO1010 are in the same subnet from Main Base Station and it accepts wireless connections from client devices. APO1000/APO1010 Figure 6-1 Client Bridge + Universal Repeater mode Configuration When the APO1000/APO1010 configured as an Access Point and Client Station simultaneously, the Wireless General and Advanced Setup also used simultaneously. But the Security Type can be different. In the other word, the channel or other settings will be the same between APO1000/APO1010 to Main Base Station and wireless client to APO1000/APO1010, but security type can be different. 117