Asko DC7171 User manual Use & Care Guide ASKO DC7171 EN - Page 17

8. Push the drying cabinet back into its final location. Remove the tape that holds the door closed and check that the shims are aligned with the back of the drying cabinet. Also check that the drying cabinet's front section fits properly into the custom cabinetry. 9. Level the drying cabinet according to section "Level drying cabinet" on page 15. 10. Pull out the upper hanger section and drill assembly holes in the wood shims for the attachment screws through the predrilled holes in the back of the drying cabinet. 11. Secure the cabinet with the supplied screws and associated washers. 1 3 4 2 ~6" (15 cm) 1. Fastening screws 2. Mounting hole markings from the predrilled holes in the rear drying cabinet wall. 3. Air flow 4. Wood shims Custom cabinetry with mounted wood shims allowing free air stream IMPORTANT: Check that the shims are properly secured to the rear wall and that the installation screws do not obstruct the drying cabinet's mounting holes. The wood shims are not included in the delivery. 5. Pre-drilled holes 6. Retaining screws with washers 5 6 Customer Care Center 1-800-898-1879 www.askousa.com 17