Asus M2N-MX DVI2 User Manual - Page 32
M2N-MX IDE Connector
View all Asus M2N-MX DVI2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
2. IDE connectors (40-1 pin PRI_IDE) The onboard IDE connectors are for Ultra DMA 133/100/66 signal cable(s). There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device(s). Drive jumper setting Single device Cable-Select or Master Two devices Cable-Select Master Slave Mode of device(s) Cable connector - Black Master Black Slave Gray Master Black or gray Slave • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices. If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting. PRI_IDE R M2N-MX M2N-MX IDE Connector PIN1 NOTE: Orient the red markings (usually zigzag) on the ID ribbon cable to PIN 1. 1-22 Chapter 1: Product introduction