Asus P5B DELUXE P5B Deluxe user's manual - Page 58

8. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default , the pin labeled "Chassis Signal" and " Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. ® P5B Deluxe +5VSB_MB Chassis Signal GND CHASSIS (Default) P5B Deluxe Chassis intrusion connector 9. ATX power connectors (24-pin EATXPWR, 2x4-pin EATX12V) These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit. +12V DC +12V DC +12V DC +12V DC ® P5B Deluxe EATX12V P5B Deluxe ATX power connectors GND GND GND GND EATXPWR +3 Volts +12 Volts +12 Volts +5V Standby Power OK Ground +5 Volts Ground +5 Volts Ground +3 Volts +3 Volts Ground +5 Volts +5 Volts +5 Volts -5 Volts Ground Ground Ground PSON# Ground -12 Volts +3 Volts 2-32 • Make sure to remove the cap on the EATX12V connector before connecting an 8-pin EPS +12V power plug. • Use only either a 4-pin ATX12V or an 8-pin EPS +12V power plug for the EATX12V connector. Chapter 2: Hardware information