Asus P5GPL-X SE Motherboard Installation Guide - Page 40
P5GPL-X SE Fan connectors - cpu support
View all Asus P5GPL-X SE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
2. Floppy disk drive connector (34-1 pin FLOPPY) This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive. Pin 5 on the connector is removed to prevent incorrect cable connection when using an FDD cable with a covered Pin 5. P5GPL-X ® FLOPPY PIN 1 NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. P5GPL-X SE Floppy disk drive connector 3. CPU and chassis fan connectors (4-pin CPU_FAN, 3-pin CHA_FAN) The fan connectors support cooling fans of 350mA~2000mA (24W max.) or a total of 1A~3.48A (41.36W max.) at +12V. Connect the fan cables to the fan connectors on the motherboard, making sure that the black wire of each cable matches the ground pin of the connector. Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside the system may damage the motherboard components. These are not jumpers! DO NOT place jumper caps on the fan connectors. GND +12V Rotation GND CPU FAN PWR CPU FAN IN CPU FAN PWM CHA_FAN P5GPL-X ® CPU_FAN P5GPL-X SE Fan connectors 1-28 Chapter 1: Product introduction