Asus P5GPL-X SE Motherboard Installation Guide - Page 42
P5GPL-X SE Chassis intrusion connecto
View all Asus P5GPL-X SE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
5. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. P5GPL-X ® (Default) CHASSIS GND Chassis Signal +5VSB_MB P5GPL-X SE Chassis intrusion connector 6. USB connectors (10-1 pin USB56, USB78) These connectors are for USB 2.0 ports. Connect the USB/GAME module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis. USB+5V USB_P8USB_P8+ GND NC USB+5V USB_P6USB_P6+ GND NC P5GPL-X ® USB56 1 P5GPL-X SE USB 2.0 connectors USB78 1 USB+5V USB_P7USB_P7+ GND USB+5V USB_P5USB_P5+ GND Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard! USB/Game module is purchased separately. 1-30 Chapter 1: Product introduction