Asus P5GPL-X SE Motherboard Installation Guide - Page 70

Advanced Chipset Settings Configure DRAM Timing by SPD [Enabled] When this item is enabled, the DRAM timing parameters are set according to the DRAM SPD (Serial Presence Detect). When disabled, you can manually set the DRAM timing parameters through the DRAM sub-items. The following sub-items appear when this item is Disabled. Configuration options: [Disabled] [Enabled] DRAM CAS# Latency [3 Clocks] Controls the latency between the SDRAM read command and the time the data actually becomes available. Configuration options: [3 Clocks] [2.5 Clocks] [2 Clocks] DRAM RAS# Precharge [4 Clocks] Controls the idle clocks after issuing a precharge command to the DDR SDRAM. Configuration options: [2 Clocks] [3 Clocks] [4 Clocks] [5 Clocks] DRAM Write Recovery Time [4 Clocks] Set the write recovery timing. Configuration options: [2 Clocks]~[15 Clocks] DRAM RAS# to CAS# Delay [4 Clocks] Controls the latency between the DDR SDRAM active command and the read/write command. Configuration options: [2 Clocks] [3 Clocks] [4 Clocks] [5 Clocks] DRAM RAS# Activate to Precharge [15 Clocks] Sets the RAS Activate timing to Precharge timing. Configuration options: [4 Clocks] ~ [15 Clocks] Hyper Path 2 [Auto] Enables or disables the memory acceleration mode feature. Configuration options: [Disabled] [Enabled] [Auto] Graphic Adapter Priority [PCI Express/PCI] Allows selection of the graphics controller to use as primary boot device. Configuration options: [PCI Express/PCI] [PCI/PCI Express] PEG Buffer Length [Auto] Sets the PCI Express Graphics card buffer length. Configuration options: [Auto] [Long] [Short] Link Latency [Auto] Sets the link latency. Configuration options: [Auto] [Slow] [Normal] PEG Link Mode [Auto] Sets the PCI Express Graphics link mode. Configuration options: [Auto] [Slow] [Normal] [Fast] [Faster] 2-24 Chapter 2: BIOS setup