Asus Rampage II GENE User Guide - Page 56
USB connectors 10-1 pin USB78; USB910; USB1112, JMicron JMB363
UPC - 610839170081
View all Asus Rampage II GENE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
3. JMicron JMB363® Serial ATA connector (7-pin SATA_E1 [black]) This connector is for a Serial ATA signal cable for an external Serial ATA hard disk drive. To enable hot-plugging, set the Controller Mode item in the BIOS setting to [AHCI], and then reboot the system. See section 3.5.3 Onboard Device Configuration for details. 4. USB connectors (10-1 pin USB78; USB910; USB1112) These connectors are for USB 2.0 ports. Connect the USB module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis. These USB connectors comply with USB 2.0 specification that supports up to 480 Mbps connection speed. Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard! You can connect the USB cable to ASUS Q-Connector (USB, blue) first, and then install the Q-Connector (USB) to the USB connector onboard. 2-32 Chapter 2: Hardware information