Asus Rampage II GENE User Guide - Page 60
Thermal sensor cable connectors 2-pin OPT_TEMP1/2, Chassis intrusion connector 4-1 pin CHASSIS
UPC - 610839170081
View all Asus Rampage II GENE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
10. Thermal sensor cable connectors (2-pin OPT_TEMP1/2) These connectors are for temperature monitoring. Connect the thermal sensor cables to these connectors and place the other ends to the devices which you want to monitor temperature. The optional fan1/2 can work with the temperature sensors for a better cooling effect. Enable OPT FAN1/2 overheat protection in BIOS if you connect thermal sensor cables to these connectors. Refer to page 3-34 for details. 11. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. 2-36 Chapter 2: Hardware information