Asus TS300-E5 User Guide - Page 192

7.1.4 Installing the RAID controller driver (for PX4 Model) Windows® Server During Windows® Server installation To install the RAID controller driver when installing Windows® Server: 1. Start the installation: • Floppy Install: Boot the computer with the Windows Server installation diskettes. • CD-ROM Install: Boot from the CD-ROM. Press F6 after the message "Press F6 if you need to install third party SCSI or RAID driver" appears. 2. When the Windows Server Setup window is generated, press S to specify an Additional Device(s). 3. Insert the FastTrak driver diskette into drive A: and press Enter. 4. Choose Promise FastTrak TX [4650, 2650] (tm) Controller from the list that appears on screen, and then press Enter. 5. Press S to use the driver on the floppy disk and then press Enter to continue with installation. 6. The Windows Server Setup screen will appear again saying "Setup will load support for the following mass storage devices:" The list will include "Promise FastTrak TX [4650, 2650] (tm) Controller". NOTE: If there are any additional devices to be installed, specify them now. When all devices are specified, continue to the next step. 7. From the Windows Server Setup screen, press the Enter. Setup will now load all device files and then continue the Windows Server installation. 7-16 Chapter 7: Driver installation