Asus Terminator Tualatin 786 MANUAL TERMINATOR TUALATIN English V1.0 - Page 56

6. Internal Audio Connectors (4-1 pin CD_IN, MODEM) These connectors allow you to receive stereo audio input from sound sources such as a CD-ROM. The MODEM connector allows the onboard audio to interface with a voice modem card with a similar connector. It also allows the sharing of mono_in (such as a phone) and a mono_out (such as a speaker) between the audio and a voice modem card. CD (Black) AUX (White) TUSC ® Left Audio Channel Ground Right Audio Channel Left Audio Channel Ground Right Audio Channel TUSC Internal Audio Connectors Modem-In (to Modem) Ground Modem-Out (from Modem) MODEM 7. ATX Power Supply Connector (20-pin block ATXPWR) This connector connects to an ATX power supply. The plug from the power supply fits in only one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned. IMPORTANT Make sure that the ATX power supply can supply at least 10mA on the +5-volt standby lead (+5VSB). You may experience difficulty in turning the system ON if the power supply cannot support the load. For Wake-On-LAN support, the ATX power supply must supply at least 720mA +5VSB. TUSC ® TUSC ATX Power Connector +3.3Volts -12.0Volts Ground Power Supply On Ground Ground Ground -5.0 Volts +5.0 Volts +5.0 Volts +3.3 Volts +3.3 Volts Ground +5.0 Volts Ground +5.0 Volts Ground Power Good +5V Standby +12.0Volts 56 Chapter 3: Motherboard Information