Audiovox ECCO Owners Guide - Page 6
Optional: Change Distance Unit System, GPS Information, Navigating, Store a Location - instructions
View all Audiovox ECCO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Optional: Change Distance Unit System You have the option to change the distance unit system from English [feet (ft)/miles (mi)] to metric [meters (m)/kilometers (km)] or back again. Note: When instructed to "press and hold" a button, press down for at least 3 seconds. 1. While the unit is in Ready mode, press and hold location 3 (e5) for 3 seconds through a sequence of messages: Hold to change units > Units set to meters [feet]. 2. Release location 3 (e5). The LCD message Ready appears. Note: Repeat the previous steps to change back. GPS Information You can view latitude, longitude, and satellite locations on the unit. While in this state, the unit will not go into Sleep mode. (See "Sleep Versus Off" on page 8.) To display GPS Information: 1. While in Ready mode, press and hold location 2 (e5). Your current latitude and longitude are displayed on the LCD. 2. While in this state, press and release location 3 (e5) to display a bar graph view of current satellite signals. 3. Press and release location 3 (e5) again, and the view changes to a globe displaying the satellite locations. 4. Press location 2 (e5) to return to Ready. (Searching may briefly display on the LCD.) Note: While viewing GPS Information, you can press Return and the unit will Refresh GPS satellite information and go to Ready. Store a LocatioNnavigating 1. While the unit is in Ready mode, press lock button (e2). The LCD message Select location appears. 2. Press location # (e5) to store your current position; then the message Location # locked appears. Proceed to your destination. Note: After 1 minute, the unit goes to Sleep, but your stored location will not be lost and will remain in memory until it is replaced with a new locked position. (See "Sleep Versus Off" on page 8.) Page 6 6/12 128-8854