Beltronics Vector 995 Owner's Manual - Page 5
Installation - direct wire
View all Beltronics Vector 995 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
31160_Vec995_OMrev 8/10/10 1:46 PM Page 9 Installation Power Connection To power V995, plug the small end of the power cord, (telephone-type connector) into the modular jack on V995's right side, and plug the lighter plug adapter into your vehicle's lighter socket or accessory socket. V995 operates on 12 volts DC negative ground only. The lighter plug provided is a standard size and will work in most vehicles. However, some vehicles may require the optional European sleeve to ensure a snug fit. If so, simply call our service department to order one. This sleeve slides over the lighter plug. Of course, your lighter socket must be clean and properly connected for proper operation. Note: Depending on your vehicle, the lighter socket power may either be continuously on, or it may be switched on and off with your ignition switch. Optional power cords See the Accessories section for details on our optional coiled SmartPlug or Direct-wire power cords. Page 29 Mounting Location WARNING: BELTRONICS cannot anticipate the many ways the V995 can be mounted. It is important that you mount V995 where it will not impair your view nor present a hazard in case of an accident. Where to mount V995 For optimum detection performance, we recommend the following: • Using the QuickMount bracket, mount your V995 level, and high enough on your front windshield to provide a clear view of the road from the front and rear. • Mount V995 away from windshield wipers, other solid objects, and heavily tinted areas that might obstruct the radar antenna or laser lens. Windshield QuickMount V995's QuickMount bracket is designed for unobtrusive and hassle-free mounting. 1 Depress the QuickMount button on the top of V995 (by the word BELTRONICS) and slide the QuickMount bracket into the slot until it is locked into the position which best fits the angle of your windshield (there are four settings available). For extremely horizontal or extremely sloped windshields, the QuickMount bracket can be bent. To ensure that the suction cups adhere to the windshield firmly, be sure to keep both your windshield and the suction cups clean. 2 To adjust V995 on your windshield, use the QuickMount adjustment button located on the top of the V995, and slide V995 forward or backward to obtain a level horizontal position. When installed and adjusted properly, the back top edge of the V995 should rest solidly against your windshield. Caution! A few vehicles (including some Porsches) have windshields with a soft anti-lacerative coating on the inside surface. Use of suction cups will permanently mar this coating. Consult your dealership or the vehicle owner's manual to determine if your windshield has this coating. User's Tip You can leave the QuickMount bracket in place on your windshield, and easily remove the V995 by pressing the adjustment button and sliding V995 off the mount. Again, be sure to position the bracket where it won't present a hazard in the event of an accident. Additional mounts are available. 6 7