BenQ PG2401PT Palette Master - How to use guide - Page 7
Select Patch.
 |
View all BenQ PG2401PT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
11 12 three In Advanced Mode ii You can change the type of ICC profile you want to use , but the default setting (ICC V4) is recommended. Select tar get " Calibr ation 1" or " Calibr ation 2" to save the calibr ation result into the monitor, then click "Star t Measurement" to calibr ate monitor. Before calibr ating, tilt the monitor up to ensure that the color imeter snaps onto the monitor. CALIBRATION 1. Select "Patch." 2. Set size according to your requirements. 3. A larger set size usually provides better accuracy, but takes longer to measure. 4. You may add specific Pantone tar gets to make the calibr ation results accur ate for your project. 5. When your settings are in place, click "Next" In Advanced Mode In Advanced Mode
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11
 |
 |
You can change the type of ICC profile you want to use, but the default setting (ICC V4) is
recommended.
1. Select “Patch.”
2. Set size according to your requirements.
3. A larger set size usually provides better accuracy, but takes longer to measure.
4. You may add specific Pantone targets to make the calibration results accurate for your project.
5. When your settings are in place, click “Next”
In Advanced Mode
In Advanced Mode
11
12
In Advanced Mode ii
three
Select target “ Calibration 1” or “ Calibration 2” to save the calibration result into the monitor,
then click “Start Measurement” to calibrate monitor.
Before calibrating, tilt the monitor up to ensure that the colorimeter snaps onto the monitor.
CALIBRATION