Bissell CrossWave Multi-Surface Wet Dry Vac 1785 User Guide - Page 7

Cleaning Your Hard Floors 1 2 3 Plug machine into a properly grounded outlet. 4 Select cleaning mode: To start cleaning your hard floors, turn the machine ON pressing the HARD FLOOR button. Once the setting is selected, the dry vacuum will turn on. To turn OFF, press the HARD FLOOR setting a second time. 5 Recline the body of the machine backward to start the brush roll spinning. To stop the brush roll spinning, you will need to stand the machine upright. 6 Before each use, hold the solution spray trigger for 10 seconds to prime the system with cleaning solution. LED lights illuminate when holding the trigger. NOTE: When solution is flowing, you will see bubbles forming at the edges of the brush roll window. To clean, hold the solution spray trigger to apply solution on both forward and backward passes. To dry hard floors faster, release the trigger and clean a second pass without dispensing solution. TIP: When cleaning excessively dirty or muddy hard floors or if your brush roll looks dirty, use the Easy Clean Storage Tray to rinse your brush roll before cleaning your area rugs. TIP: For overly challenging and stuck-on messes on your hard floors, activate the RUG mode and hold your CrossWave™ over the mess. Using short passes while holding the trigger allows the multi-surface brush to go to work. www.BISSELL.com 7