Bissell Pet Hair Eraser Upright Vacuum 1650 User Guide - Page 11
LED Lighted Crevice Tool, Vacuum Motor Protection
View all Bissell Pet Hair Eraser Upright Vacuum 1650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
LED Lighted Crevice Tool 1 2 Pull tabs out of battery door area before use to activate. Connect to handle, wand or hose and the LED Light will automatically come on. To replace LED battery, unscrew the small screw with a Phillips head screw driver. Pull cover off to reveal two batteries (CR1632 3V). Slide and pull out each battery and replace with new. Be sure the "+" sign on battery is facing out. Dispose of used battery promptly. Keep away from children. Do not disassemble and do not dispose of in fire. NOTE: When the small tab on the connection point of Crevice tool comes into contact with the handle, wand, or hose; that triggers the LED light to come on. When using with the Wand, be sure it does not pop through the opening at the end of the Wand. Vacuum Motor Protection An internal thermal protector has been designed into your vacuum to protect it from overheating. When the thermal protector activates, the main vacuum motor will stop operating. If this happens, proceed as follows. 1 Turn vacuum OFF and unplug from electrical outlet. 2 Check for the source of overheating problem (full dirt cup, dirty filters or, a clog) and fix by following the maintenance instructions. Filter 3 When the motor cools for approximately 30 minutes, the thermal protector automatically resets and cleaning may continue. If the vacuum will not turn on or the thermal protector continues to activate, your vacuum may need servicing. Filter Call BISSELL Consumer Care. NOTE: The thermal protector controls the main vacuum motor only, not the brush motor. If the thermal protector activates, the brush will continue to operate normally; however, there will be no suction. Possible areas that could clog. www.BISSELL.com 11