Bissell PowerLifter PowerBrush Upright Carpet Cleaner 1622 User Guide - Page 9

Maintenance and care Machine care continued 3. Replace the 2-in-1 water tank on the machine. 4. Any loose hair or debris can be pulled from the brush roll if desired and thrown away. 5. Wipe the machine's exterior with a soft cloth. 6. After carpet is dry, vacuum again to remove hair and fuzz. Machine storage Put the unit away in a closet or basement for the next use. Store cleaner in a protected, dry area. Since this product uses water, it must not be stored where there is a danger of freezing. Freezing will damage internal components and void the warranty. WARNING: To reduce the risk of fire, electric shock or injury, unplug from the outlet before servicing. Troubleshooting Reduced Spray OR No Spray Possible cause 1. Bladder may be empty 2. 2-in-1 tank may not be seated properly. 3. Pump may have lost prime. 4. The pump belt may be broken. A. B. Slots Remedies 1. Turn power switch OFF (O); Refill bladder with clean hot tap water. 2. Turn power switch OFF (O); remove tank and reseat tanks. 3. Turn power switch OFF (O); after 1 minute turn ON (I) and depress spray release trigger. 4. Turn power switch OFF (O) and unplug from the outlet. To check if a pump belt has broken, you will need a flat head screwdriver. A. Insert the blade end into the slot of the belt access door to release. Examine the belt for breakage. You should be able to see the pump belt looped around the motor shaft. If it is broken or missing, please refer to Replacement Parts on page 11. A replacement belt may be ordered at www.bissell.com or by calling BISSELL Consumer Services at 800-237-7691. Complete installation instructions will accompany the replacement belt. Pump Belt B. When replacing belt access door be sure to line up slots of belt access door with slots in machine, slide door into place and snap shut. www.bissell.com 800.237.7691 9